3-52, ISDN Trunk Directory Number Assignment DRAFT 3 Chapter 1 – 385
Xen IPK Programming Manual
Doc. No.: 8194 - Release 2.0
December 2004
3-52
System Mode
3
Submode
—
Data No.
52
PC Programming
+ AV
ISDN Trunk Directory
Number Assignment
General Description
Use this Memory Block to assign the Integrated Services Digital Network (ISDN)
Directory Number.
Display
Programming Procedures
1
Go off-line.
2
Press LK3 + N + EB to access the Memory Block.
3
Enter Data using the Dial Pad:
Note: Use the following to enter data:
J to move the cursor left
L to move the cursor right
K~I to enter numeric data
R to go to the next CO/PBX Line No.
4
PressNto write the data.
5
PressPto go back on-line.
Related Programming
No related programming is necessary for this Memory Block.
N
1. If CFE feature is to be used, the GDN number must be set for BRI.
2. If DID is used in conjunction with PRI, do not assign any number to CO.
3. Enter the Area Code as part of directory number, e.g. Melbourne = 3xxxx xxxx
0 1 / 5 2 :
T I M E D I S P L A Y
CO/PBX
No.
(01~64)
Data
No.
Setting Data
(20 digits maximum)
To Next Page
Loading...
