NEC Xen IPK - Intercom Master Hunt Number Selection

422 – Chapter 1 DRAFT 3 Intercom Master Hunt Number Selection, 4-14
December 2004 NEC Business Solutions Ltd
Doc. No.: 8194 - Release 2.0 December 2004
4-14
System Mode
4
Submode
—
Data No.
14
PC Programming
+ BTT
Intercom Master Hunt
Number Selection
General Description
Use this memory block to assign a master intercom number to each telephone.
Display
Settings
LK 1 LK 2 LK 3 LK 4
The shaded area indicates
the default setting.
No Yes
LK 5 LK 6 LK 7 LK 8
Programming Procedures
1
Go off-line.
2
Press LK4 +AD to access the Memory Block.
3
Press the corresponding CO/PBX line key to change data option
Note: Use the following to change option:
R to move to the next Tel Port No.
4
PressNto write the data.
5
PressPto go back on-line.
Related Programming
M.B. Number Memory Block Name
4-15 Intercom Master Hunt Number Forward Assignment
N
1. If Yes is assigned, an incoming internal call from another station, Automated Attendant transferred call, or DIT/ANA/
DID/Tie line designated call is forwarded to a station specified in Memory Block , 4-15 , Intercom Master Hunt Number
Forward Assignment if line is busy.
2. Telephone ports A0~C0 are ports 100~120.
0 1 / 1 4 : M S T E R N O
T I M E D I S P L A Y
Data
No.
Tel Port
No.
(01~99)
A0~C0
Setting
Data
Title