NEC Xen IPK - Specified Station Access Code Assignment

1-2-08, Specified Station Access Code Assignment DRAFT 3 Chapter 1 – 135
Xen IPK Programming Manual
Doc. No.: 8194 - Release 2.0 December 2004
1-2-08
System Mode
1
Submode
2
Data No.
08
PC Programming
+BA
Specified Station Access Code
Assignment
General Description
Use this Memory Block to assign specific stations to be called using abbreviated dialling. Up to
24 stations can be assigned.
Display
Programming Procedures
1
Go off-line.
2
Press LK1 + LK2 + KHto access the Memory Block.
3 Enter the options using the dial pad.
Note: Use the following to enter data:
J to move the cursor left
L to move the cursor right
U to clear data
Default Values
4
Press Nto display the Tel. Port No. 01.
5
After entering the Specified Station No. Access Code, press Nto advance to the next Station No.
6
PressNto write the data.
7
PressPto go back on-line.
Related Programming
M.B. Number Memory Block Name
1-1-46 Access Code (1-Digit) Assignment
1-1-47 Access Code (2-Digit) Assignment
1-4-14 Automated Attendant Message Access Code (1-Digit) Assignment
1-4-15 Automated Attendant Message Access Code (2-Digit) Assignment
N
1. Specified stations can be accessed from intercom (ICM) dial tone or as an outside caller calling into the Xen IPK
system via Auto Attendant.
2. The Specified Access Code is assigned in Memory Blocks 1-1-46 , Access Code (1-Digit) Assignment or 1-1-47,
Access Code (2-Digit) Assignment.
0 8 : S P C L E X T 0 0 = 0 1
T I M E D I S P L A Y
Title
Data
No.
Specified
Station
Access
Code
00~23
Tel. Port
No.
00~99
A0~A9
B0~B9C0
Setting Data
Tel. Port No. 01~120
Specified Station Access Code is 00~23
Access
Code No.
Value
00 01
01-23 Not Set