164 – Chapter 1 DRAFT 3 SLT/PHS Talk Start Timer, 1-3-11
December 2004 NEC Business Solutions Ltd
Doc. No.: 8194 - Release 2.0
December 2004
1-3-11
System Mode
1
Submode
3
Data No.
11
PC Programming
+ BTI
SLT/PHS Talk Start Timer
General Description
Use this Memory Block to assign the time needed after a hookflash and dialling before three-
party (two Cos and one SLT) line conference is allowed from a Single Line Telephone or
PHS handset.
Display
Programming Procedures
1
Go off-line.
2
Press LK1 + LK3 + AA to access the Memory Block.
3 Use the dial pad to enter data.
NOTE: Use the following to enter data:
A ~I to enter numeric data
Jto move the cursor left
Lto move the cursor right
Setting Data: 01~99 sec
Default Values
10 sec
4
PressNto write the data and display the next Memory Block
5
Program the next Memory Block or pressPto go back on-line.
Related Programming
M.B. Number Memory Block Name
1-8-08 Class of Service (Station) Feature Selection 2 (Page 3, LK5)
3-04 Trunk-to-Trunk Transfer Yes/No Selection
4-17 Station to Class of Service Feature Assignment
1 1 : T L K T M R = 1 0 s
T I M E D I S P L A Y
Setting
Data
Title
Data
No.
To Next Page
Loading...
