NEC Xen IPK - Timer Class Assignment for Telephone Mode Selection

468 – Chapter 1 DRAFT 3 Timer Class Assignment for Telephone Mode Selection, 4-64
December 2004 NEC Business Solutions Ltd
Doc. No.: 8194 - Release 2.0 December 2004
4-64
Submode
4
System Mode
—
Data No.
64
PC Programming
+ BTT
Timer Class Assignment for
Telephone Mode Selection
General Description
This Memory Block assigns class of flexible timer to Extenstions. Applicable to IPK R2000.
Display
Programming Procedures
1
Go off-line.
2
Press LK4 +GA to access the Memory Block.
3 Use the following to enter data:
Jto move the cursor left.
Lto move the cursor right.
K~Ito enter numeric data.
Setting Data (Allow):
1 (Class 1) to 4 (Class 4)
– OR –
Press
Rto go to the next TEL port number.
Default
Class 1
4
PressNto write the data and display Memory Block , 4-01.
5
Program Memory Block, 4-01 or pressPto go back on-line.
Related Programming
M.B. Number Memory Block Name
1-1-03 Hold Recall Timer Selection (Non-Exclusive Hold)
1-1-05 Start Timer Selection
1-1-06 CO/PBX Incoming Ringing Alarm Time Selection
1-1-07 Tie/DID Line Delay Ringing Timer Selection
1-1-12 Station Transfer/Camp-On Recall Timer Selection
1-1-37 Trunk Queuing Timeout Selection
1-1-63 Hold Recall Time Selection (Exclusive)
1-1-81 ISDN Dial Interval Timer
1-2-00 Internal Paging Timeout Selection
0 1 / 7 1 : T M R C L S = 1 5
T I M E D I S P L A Y
Data
No.
Tel Port No.
(01~CO)
Setting
Data