1-11-05, TI Channel Selection DRAFT 3 Chapter 1 – 265
Xen IPK Programming Manual
Doc. No.: 8194 - Release 2.0
December 2004
1-11-05
System Mode
1
Submode
11
Data No.
05
PC Programming
+ AD
TI Channel Selection
General Description
Use this Memory Block to specify the digital trunk interface (DTI) channel numbers to be
used. DTI Trunks 1 and 2 have a maximum of 24 channels, and DTI Trunk 3 has a
maximum of 16 channels
.
Applicable for R2000 and above.
Display
Programming Procedures
1
Go off-line.
2
Press LK1 + LK11 + KE to access the Memory Block.
3
Press the corresponding CO/PBX line key to select DTI channel number.
Default Values
DTI No. 1 Channels 01~24 = Off
DTI No. 2 Channels 01~24 = Off
DTI No. 3 Channels 01~24 = Off
DTI No. 4 Channels 01~24 = Off
DTI No. 5 Channels 01~24 = Off
DTI No. 6 Channels 01~24 = Off
DTI No. 7 Channels 01~24 = Off
DTI No. 8 Channels 01~24 = Off
4
PressNto write the data. The next Memory Block is displayed.
5
Program the next Memory Block or pressPto go back on-line.
Related Programming
M.B. Number Memory Block Name
7-1 Card Interface Slot Assignment
N
The DTI-U( ) ETU must be assigned in the system to set this Memory Block.
0 1 / 0 5 C H A N E L | 0 1
T I M E D I S P L A Y
Data
No.
Title
Setting
Data
DTI No.
(01~08)
CO/PBX
Line Key
Channel No.
Page
DTI No.
1
DTI No.
2
DTI No.
3~8
01~08 01~08 01~08 01~08 1
09~16 09~16 09~16 09~16 2
17~24 17~24 17~24 17~24 3
CO/PBX
Line LED
Off On
Data
NO
(Not Assigned)
YES
(Assigned)
To Next Page
Loading...
