NEC Xen IPK - Digits Delete for TI ANI Assignment

268 – Chapter 1 DRAFT 3 Digits Delete for TI ANI Assignment, 1-11-08
December 2004 NEC Business Solutions Ltd
Doc. No.: 8194 - Release 2.0 December 2004
1-11-08
System Mode
1
Submode
11
Data No.
08
PC Programming
+ AD
Digits Delete for TI ANI
Assignment
General Description
Use this Memory Block to delete the Information Digits received from the Network on
Feature Group D Trunks
.
Applicable for R2000 and above.
Display
Programming Procedures
1
Go off-line.
2
Press LK1 + LK11 + KH to access the Memory Block.
3
Use the dial pad to enter Setting Data 1 and Setting Data 2
.
Note:
Use the following to enter data:
Jto move cursor left.
Lto move cursor right.
K~I to enter data
KA~KC to change DTI number
Note: Setting Data 1:
Press the corresponding CO/PBX line key to change the data option.
Note: Setting Data 2:
0No Delete
1~9 Number of Digits to Delete
Default Values
2
4
PressNto write the data. Memory Block 1-11-00 is displayed.
5
Program Memory Block 1-11-00 again
or pressPto go back on-line.
0 1 / 0 8 : 1 – D E L 2 D G T
T I M E D I S P L A Y
Data
No.
Title
Setting
Data
DTI No.
(01~08)
Block
1~6
Block
No.
4-Channel Unit
DTI
No. 1
DTI
No. 2
DTI
No. 3~8
1 01~04 01~04 01~04
2 05~08 05~08 05~08
3 09~12 09~12 09~12
4 13~16 13~16 13~16
5 17~20 17~20 17~20
6 21~24 21~24 21~24