NEC Xen IPK - CO;PBX Outgoing Digit Add Assignment

1-1-50, CO/PBX Outgoing Digit Add Assignment DRAFT 3 Chapter 1 – 85
Xen IPK Programming Manual
Doc. No.: 8194 - Release 2.0 December 2004
1-1-50
System Mode
1
Submode
1
Data No.
50
PC Programming
+ BCS
CO/PBX Outgoing Digit Add
Assignment
General Description
Use this Memory Block to specify up to 10 additional digits when a trunk in the Trunk Group or
Route Advance block assigned in Memory Block 1-1-49 Networking Trunk Group/Route Advance
Assignment is seized, and a number is dialled.
Display
Programming Procedures
1
Go off-line.
2
Press LK1 + LK1 + EK to access the Memory Block.
3
Use dial pad to enter digits to be added.
Note: Use the following to enter data:
J to move the cursor left
L to move the cursor right
K~Ito enter numeric data
U to clear all data
Q+ J to enter *
Q+ L to enter #
Default Values
Not Specified
4
PressNto write selected data.
5
PressPto go back on-line.
Related Programming
M.B. Number Memory Block Name
1-1-46 Access Code (3-Digit) Assignment
1-1-49 Networking Trunk Group/Route Advance Assignment
5 0 : 0 1 =
T I M E D I S P L A Y
Data
No.
Closed
Number Block
01~16
Add Digit
10 Max. (0~9, *, #)