NEC Xen IPK - Page 106

December 2004 NEC Business Solutions Ltd
86 – Chapter 1 DRAFT 3 CO/PBX Outgoing Digit Add Assignment, 1-1-50
Doc. No.: 8194 - Release 2.0 December 2004
N
To assign System 1 in System Programming:
1. Memory Block 1-1-46 Access Code (1-Digit) Assignment. Assignment 2
→ 401 (Closed Number Block 01).
2. Memory Block 1-1-49 Networking Trunk Group/Route Advance Assignment. Assignment Block 01
→ 102 (Trunk
Group 02).
3. Memory Block 1-1-50 CO/PBX Outgoing Digit Add Assignment. Assignment Block 01
→ Assign 2
4. Digits are added when the Access Code is dialled from the internal dial tone.
5. This Memory Block also applies to ISDN trunks.
Example:
St
a
ti
on
100
Dials 200
Add
200


Xen IPK
System
Xen IPK
System
Station 200 Rings
Trunk
Group 02