NEC Xen IPK - Dial-In Tenant Incoming Limit Assignment

338 – Chapter 1 DRAFT 3 Dial-In Tenant Incoming Limit Assignment, 2-09
December 2004 NEC Business Solutions Ltd
Doc. No.: 8194 - Release 2.0 December 2004
2-09
System Mode
2
Submode
—
Data No.
09
PC Programming
+ BN
Dial-In Tenant Incoming
Limit Assignment
General Description
Use this Memory Block to assign names for telephone stations.
Display
Programming Procedures
1
Go off-line.
2
Press LK2 + K I to access the Memory Block.
3
Use the dial pad to enter data.
Note: Use the following to enter data:
J to move the cursor left
L to move the cursor right
K~I to enter numeric data
R to go to next Tenant.
Setting Data: 0 = No Limit
1~64 = Number of effective incoming
Default Values
No Limit = 0
4
PressNto write the data.
5
After entering all data, pressN
6
PressPto go back on-line.
Related Programming
M.B. Number Memory Block Name
2-01 Trunk to Tenant Assignment
N
Only DID incoming calls are limited. Outgoing calls, Internal (ICM) calls, and normal incoming calls are not limited.
0 0 / 0 9 : L I M I T 0 0
T I M E D I S P L A Y
Data
No.
Tel Port
No.
(00~47)
A0~C0
Title
Data