NEC Xen IPK - Automatic Tandem Trunk Assignment

3-06, Automatic Tandem Trunk Assignment DRAFT 3 Chapter 1 – 345
Xen IPK Programming Manual
Doc. No.: 8194 - Release 2.0 December 2004
3-06
System Mode
3
Submode
—
Data No.
06
PC Programming
+ AT
Automatic Tandem Trunk
Assignment
General Description
Use this Memory Block to specify the incoming trunk and outgoing trunk for Automatic Trunk-to-
Trunk Transfer.
Display
Programming Procedures
1
Go off-line.
2
Press LK3 +N+ KFto access the Memory Block.
3
Enter data using the dial pad.
Note: Use the following to enter data:
J to move the cursor left
L to move the cursor right
K~I to enter numeric data
R to go to the next CO/PBX Line No.
Default Values
Not Specified
4
PressNto write the data.
5
PressPto go back on-line.
Related Programming
M.B. Number Memory Block Name
3-04 Trunk-to-Trunk Transfer Yes/No Selection
3-05 Trunk Incoming Answer Mode Selection
0 1 / 0 6 : T A N D C O =
T I M E D I S P L A Y
Data
No.
Setting
Data
Title
(Incoming)
CO/PBX
No.
(01~64)