NEC Xen IPK - DID Digit Length Selection

54 – Chapter 1 DRAFT 3 DID Digit Length Selection, 1-1-20
December 2004 NEC Business Solutions Ltd
Doc. No.: 8194 - Release 2.0 December 2004
1-1-20
System Mode
1
Submode
1
Data No.
20
PC Programming
+ ALN
DID Digit Length Selection
General Description
This Memory Block defines the Direct Inward Dialling (DID) digit length in Memory
Block 1-1-22.
Display
Programming Procedures
1
Go off-line.
2
Press LK1 + LK1 + BK to access the Memory Block.
3
Enter the data using the dial pad.
Note: Use the following to enter data:
J to move the cursor left
L to move the cursor right
K~I to enter numeric data 2, 3, or 4
Q to insert a pause
U to clear all data
Default Values
2
4
PressNto write the data.
5
PressPto go back on-line.
Related Programming
M.B. Number Memory Block Name
1-1-21 DID Digit Conversion Assignment
1-1-22 DID Digit Conversion Table & DNIS Assignment
1-1-23 DID Forward Station Number for Busy Station or Undefined Digit
5-00 Digit Add/Del for Tie Line Networking
2 0 : D I D D G T 2
T I M E D I S P L A Y
Data
No. Title
Setting
Data