NEC Xen IPK - Trunk Queuing Timeout Selection

74 – Chapter 1 DRAFT 3 Trunk Queuing Timeout Selection, 1-1-37
December 2004 NEC Business Solutions Ltd
Doc. No.: 8194 - Release 2.0 December 2004
1-1-37
System Mode
1
Submode
1
Data No.
37
PC Programming
+ BM
Trunk Queuing Timeout
Selection
General Description
Use this Memory Block to specify the time that a station with Trunk Queue set rings, before the
queue is automatically cancelled.
With IPK R2000 and above, this memory block allows flexible entries and has four classes.
For R2000 only.
For R2000 and above.
Display
Settings
LK 1 LK 2 LK 3 LK 4
The shaded area indicates
the default setting.
10 sec. 20 sec. 30 sec. 60 sec.
LK 5 LK 6 LK 7 LK 8
Programming Procedures
1
Go off-line.
2
Press LK1 + LK1 + CGto access the Memory Block.
3
Press the corresponding CO/PBX line key to change the data option.
4
PressNto write the data.
5
PressPto go back on-line.
Display
Programming Procedures
1
Go off-line.
2
Press LK1 + LK1 + CGto access the Memory Block.
3 7 : T R U N K Q U E 1 0 s
T I M E D I S P L A Y
Data
No. Title
Setting
Data
3 7 : T R K Q U E X = 1 0 s
T I M E D I S P L A Y
Data
No. Title
Setting
Data
Class