Xen IPK Programming Manual
1-1-37, Trunk Queuing Timeout Selection DRAFT 3 Chapter 1 – 75
Doc. No.: 8194 - Release 2.0
December 2004
3
Use the dial pad to enter the time required.
Note:
Jto move cursor left.
Lto move cursor right.
Setting Data (Allow): Class 1 to Class 4: 000 to 999
sec
000 = No
Limit
Default values:
Class 1 to Class 4 = 10 secs
4
PressNto write the data.
5
PressPto go back on-line.
Related Programming
4-71 Time Class Assignment for Telephone Mode (R2000 and above)
N
When all trunks in a particular Trunk Group are busy, the station user can dial an Access Code to queue on the busy
Trunk Group. When a Trunk (in that group) becomes idle, the queued station is signalled.
Programming Procedures (Continued)
To Next Page
Loading...
