NEC Xen IPK - Digit Matching Table to Class Assignment

100 – Chapter 1 DRAFT 3 8-Digit Matching Table to Class Assignment, 1-1-61
December 2004 NEC Business Solutions Ltd
Doc. No.: 8194 - Release 2.0 December 2004
1-1-61
System Mode
1
Submode
1
Data No.
61
PC Programming
+ AC
8-Digit Matching Table to
Class Assignment
General Description
Use this Memory Block to program, per Class, each 8-digit Matching Table to allow or deny.
Classes 00 and 15 are fixed. Only classes 01
~14 can be programmed.
Display
Settings
LK 1 LK 2 LK 3 LK 4
The shaded area indicates
the default setting.
NON
Allow (YS) Deny (NO)
LK 5 LK 6 LK 7 LK 8
Programming Procedures
1
Go off-line.
2
Press LK1 + LK1 + FA to access the Memory Block.
3
Press the corresponding CO/PBX line key to change the data option.
Note: Class 00 and 15 cannot be programmed.
Class 00 has no restrictions (Allow)
Class 15 has restricted outgoing (Deny)
Refer to the table on the next page.
4
PressNto write the data and advance to the next table. Repeat Steps 3 and 4 for each table.
5
After data for the last table is entered, pressNto write the data.
6
PressPto go back on-line.
Related Programming
M.B. Number Memory Block Name
Refer to Section 6 Code Restriction in this chapter.
6 1 : C L S 0 1 ( 0 0 ) = Y S
T I M E D I S P L A Y
Data
No.
Title
1~7
Class
No.
01~14
Table
00~15
Setting
Data