150 – Chapter 1 DRAFT 3 PS Out of Area Tone Selection, 1-2-28
December 2004 NEC Business Solutions Ltd
Doc. No.: 8194 - Release 2.0
December 2004
1-2-28
System Mode
1
Submode
2
Data No.
28
PC Programming
+AP
PS Out of Area Tone Selection
General Description
Use this Memory Block to specify whether a call to a PS Handset which is currently out of
coverage area will receive Busy Tone (BT) or Ring Back Tone (RBT).
Display
Settings
LK 1 LK 2 LK 3 LK 4
The shaded area indicates
the default setting.
BT RBT
LK 5 LK 6 LK 7 LK 8
Programming Procedures
1
Go off-line.
2
Press LK1 + LK2 + BH to access the Memory Block.
3
Press the corresponding CO/PBX line key to change the data option.
4
PressNto write data.
5
PressPto go back on-line.
Related Programming
No related programming is necessary for this Memory Block.
N
Ring Back Tone is the ringing tone head by the caller.
Refer to the Features and Specifications Manual, feature M6 - Multi-zone Digital Cordless for instructions with VM when
PHS phone is set to CFBNA and turn off or out of area.
2 8 : P S T O N E = B T
T I M E D I S P L A Y
Data
No.
Title
Setting
Data
To Next Page
Loading...
