NEC Xen IPK - ISDN Dial-Out Sending Selection

388 – Chapter 1 DRAFT 3 ISDN Dial-Out Sending Selection, 3-57
December 2004 NEC Business Solutions Ltd
Doc. No.: 8194 - Release 2.0 December 2004
3-57
System Mode
3
Submode
—
Data No.
57
PC Programming
+ AU
ISDN Dial-Out Sending
Selection
General Description
Use this Memory Block to specify whether a an ISDN call is to be sent En Block or Overlap.
Applicable to IPK R2000 and above.
Display
Settings
LK 1 LK 2 LK 3 LK 4
The shaded area indicates
the default setting.
OV EN
LK 5 LK 6 LK 7 LK 8
Programming Procedures
1
Go off-line.
2
Press LK3 +N+ E G to access the Memory Block.
3
Press the corresponding CO/PBX line key to change the data option.
Note: Use the following to enter data:
R to go to the next CO/PBX Line No.
4
PressNto write the data.
5
PressPto go back on-line.
Related Programming
M.B. Number Memory Block Name
7-1 Card Interface Slot Assignment
1-13-00 PRI Channel Assignment
1-13-04 PRT B Channel Outgoing Priority Selection
3-03 Trunk-to-Trunk Group Assignment
3-91 Trunk Type Selection
1-1-81 ISDN Dial Out Interval Timer
0 1 / 5 7 : D I A L I N G O V
T I M E D I S P L A Y
CO/PBX
No.
(01~64)
Setting Data
Data
No.