NEC Xen IPK - Automated Attendant Message to Trunk Selection

378 – Chapter 1 DRAFT 3 Automated Attendant Message to Trunk Selection, 3-38
December 2004 NEC Business Solutions Ltd
Doc. No.: 8194 - Release 2.0 December 2004
3-38
System Mode
3
Submode
—
Data No.
38
PC Programming
+ AU
Automated Attendant Message
to Trunk Selection
General Description
Use this Memory Block to assign the Automated Attendant Message per-CO/PBX Trunk. When
the Automated Attendant Message is assigned to each CO/PBX Trunk, the system automatically
answers the incoming call and sends an Automated Attendant Message to the calling party.
Display
Programming Procedures
1
Go off-line.
2
Press LK3 +N+ CHto access the Memory Block.
3
Enter data using the dial pad.
Setting Data:
1~8 Automated Attendant Message 1~8
Note: Use the following to enter data:
R : Next CO/PBX Line No.
Default Values
Message 1
4
PressNto write the data.
5
PressPto go back on-line.
Related Programming
No related programming is necessary for this Memory Block.
N
The attendant telephone position must dial an Access Code to activate this feature.
0 1 / 3 8 : A A M S G = 1
T I M E D I S P L A Y
Data
No.
Setting
Data
CO/PBX
No.
(01~64)
Title