NEC Xen IPK - K-CCIS Main;Remote Office Selection

1-15-00, K-CCIS Main/Remote Office Selection DRAFT 3 Chapter 1 – 291
Xen IPK Programming Manual
Doc. No.: 8194 - Release 2.0 December 2004
1-15-00
System Mode
1
Submode
15
Data No.
00
PC Programming
+ AW
K-CCIS Main/Remote Office
Selection
General Description
Use this Memory Block to activate K-CCIS by assigning a Main or Remote system.
Applicable for IPK R2000 and above.
Display
Settings
LK1 LK2 LK3 LK4 LK5 LK6 LK7 LK8
The shaded area indicates
the default setting.
NONE MAIN REMOTE
Programming Procedures
1
Go off-line.
2
Press LK1 + LK15 to access the Memory Block.
3
Press the corresponding CO/PBX line key to change the Setting Data option.
4
PressNto write the data.
5
PressPto go back on-line.
Related Programming
M.B. Number Memory Block Name
7-1 Card Interface Slot Assignment
7-3-01 MIF (LCR) Assignment
7-3-02 MIF (SMDR) Assignment
1-15-02 Common Signal Channel Assignment
1-15-03 Originating Point Code Assignment
1-15-04 Destination Point Code Assignment
1-15-05 Destination Point Code Transfer Assignment
1-15-06 Originating Office Code Number Assignment
1-15-07 K-CCIS Message Response Timeout Assignment
1-15-08 Link Reconnect Allow/Deny Selection
1-15-09 K-CCIS Maximum Call Forwarding Hop Assignment
1-15-10 Calling Name Display Allow/Deny Selection
1-15-11 Centralised Billing Allow/Deny Selection
1-15-12 Centralised Billing – Point Code of Center Office Assignment
0 0 : C C I S N O N E
T I M E D I S P L A Y
Data
No.
Title
Setting
Data