NEC Xen IPK - Hold Tone Automated Attendant Selection

396 – Chapter 1 DRAFT 3 Hold Tone Automated Attendant Selection, 3-65
December 2004 NEC Business Solutions Ltd
Doc. No.: 8194 - Release 2.0 December 2004
3-65
System Mode
3
Submode
—
Data No.
65
PC Programming
+ BCT
Hold Tone Automated
Attendant Selection
General Description
Use this Memory Block to specify which message is to be played for a particular trunk.
Display
Settings
(Page 1)
LK 1 LK 2 LK 3 LK 4
The shaded area indicates
the default setting.
NONE MSG1 MSG2 MSG3
LK 5 LK 6 LK 7 LK 8
MSG4 MSG5 MSG6 MSG7
(Page 2)
LK 1 LK 2 LK 3 LK 4
MSG8
LK 5 LK 6 LK 7 LK 8
Programming Procedures
1
Go off-line.
2
Press LK3 + N + FE to access the Memory Block.
3
Press the corresponding CO/PBX line key to change the data option.
Note: The following to enter data:
S to go to the next page
T to go to the previous page
R to go to the next CO/PBX Line No.
4
PressNto write the data.
5
PressPto go back on-line.
Related Programming
M.B. Number Memory Block Name
3-61 Automated Attendant Function Selection
0 1 / 6 5 : I N C M S G N O N E 1
T I M E D I S P L A Y
CO/PBX
No.
(01~64)
Data
No.
Title
Setting
Data
Page
No.