NEC Xen IPK - Caller ID Display Assignment for CO;PBX Line

3-44, Caller ID Display Assignment for CO/PBX Line DRAFT 3 Chapter 1 – 383
Xen IPK Programming Manual
Doc. No.: 8194 - Release 2.0 December 2004
3-44
System Mode
3
Submode
—
Data No.
44
PC Programming
+ BCT
Caller ID Display Assignment
for CO/PBX Line
General Description
Use this Memory Block to assign one Multiline Terminal, per CO/PBX, line to display Caller ID
Indication on incoming CO/PBX calls.
Display
Programming Procedures
1
Go off-line.
2
Press LK3 +N+ DDto access the Memory Block.
3
Enter data using the dial pad.
Note: The following are used when entering data:
J to move the cursor left
L to move the cursor right
K~I to enter numeric data
Default Values
Not Specified
4
PressNto write the data.
5
PressPto go back on-line.
Related Programming
M.B. Number Memory Block Name
Refer to Chapter 2, Guide to Feature Programming.
N
To display Caller ID Indication for normal incoming CO calls and CAR incoming calls, both Caller ID Indication and Ring
assignment must be assigned for the terminal in System Programming. A maximum of 15 Multiline Terminals can be
assigned system-wide to display caller identification for normal incoming CO calls and CAR incoming calls using Memory
Block , 1-1-78 , Caller ID Display Assignment for System Mode. A third Multiline Terminal can be assigned to display
caller identification for normal incoming CO calls, per CO line, using this Memory Block.
0 1 / 4 4 : C A L L I D 0 0
T I M E D I S P L A Y
CO/PBX
No.
(01~64)
Data
No.
Tel
Port No.
01~C0
Title