NEC Xen IPK - DSS Call Voice;Tone Signal Selection

198 – Chapter 1 DRAFT 3 DSS Call Voice/Tone Signal Selection, 1-6-03
December 2004 NEC Business Solutions Ltd
Doc. No.: 8194 - Release 2.0 December 2004
1-6-03
System Mode
1
Submode
6
Data No.
03
PC Programming
+ BTD
DSS Call Voice/Tone Signal
Selection
General Description
Use this Memory Block to specify which is to be used first, Voice or Tone signalling, when calling
an extension from an Attendant Add-On Console.
Display
Settings
LK 1 LK 2 LK 3 LK 4
The shaded area indicates
the default setting.
Tone
Voice
LK 5 LK 6 LK 7 LK 8
Programming Procedures
1
Go off-line.
2
Press LK1 + LK6.
3
UseJto move cursor to the second Data No. position and pressCto access the Memory Block.
4
Press the corresponding CO/PBX line key to change the data option.
5
PressNto write the data.
6
PressPto go back on-line.
Related Programming
M.B. Number Memory Block Name
1-6-00 Attendant Add-On Console to Telephone Port Assignment
N
1. Voice/tone signalling can also be switched by dialling 1 from a station.
2. If tone signalling is programmed in this Memory Block, the called party cannot answer handsfree unless the Direct
Station Select (DSS) station switches it to Voice by dialling 1.
0 3 : V O I C E C A L L
T I M E D I S P L A Y
Data
No.
Setting
Data