NEC Xen IPK - Trunk Incoming Answer Mode Selection

3-05, Trunk Incoming Answer Mode Selection DRAFT 3 Chapter 1 – 343
Xen IPK Programming Manual
Doc. No.: 8194 - Release 2.0 December 2004
3-05
System Mode
3
Submode
—
Data No.
05
PC Programming
+ BCT
Trunk Incoming Answer
Mode Selection
General Description
This Memory Block specifies, per outside line, the incoming answer mode (Automatic Trunk-to-
Trunk Transfer, Automated Attendant, or DISA).
Display
Settings
LK 1LK 2LK 3LK 4
The shaded area indicates
the default setting.
Normal
Automatic
Trunk-to-
Trunk
Transfer
Automated
Attendant/
DISA
LK 5 LK 6 LK 7 LK 8
Programming Procedures
1
Go off-line.
2
Press LK3 + N + KEto access the Memory Block.
3
Press the corresponding CO/PBX line key to change the data option.
Note: Use the following to enter data:
R to go to the next CO/PBX Port No.
4
PressNto write the data.
5
PressPto go back on-line.
Related Programming
M.B. Number Memory Block Name
Refer to Chapter 2, Guide to Feature Programming.
0 1 / 0 5 : N O A S S I G N
T I M E D I S P L A Y
CO/PBX
No.
(01~64)
Data
No.
Setting
Data
Line Key
LCD Indication
when Selected
Definition
LK 1 NO ASSIGN Normal
LK 2 TANDM TRF Automatic Trunk-to-Trunk Transfer
LK 3 AA Automated Attendant/DISA