310 – Chapter 1 DRAFT 3 Calling Name Display Allow/Deny Selection, 1-15-10
December 2004 NEC Business Solutions Ltd
Doc. No.: 8194 - Release 2.0
December 2004
1-15-10
System Mode
1
Submode
15
Data No.
10
PC Programming
+ AW
Calling Name Display Allow/
Deny Selection
General Description
Use this Memory Block per Common Signalling Channel to allow or deny sending the
station name
.
Applicable for IPK R2000 and above.
Display
Settings
LK1 LK2 LK3 LK4 LK5 LK6 LK7 LK8
The shaded area indicates
the default setting.
NO YS
Programming Procedures
1
Go off-line.
2
Press LK1 + LK15 + AK to access the Memory Block.
3
Press the corresponding CO/PBX line key to change the option.
4
PressNto write the data.
5
PressPto go back on-line.
Related Programming
M.B. Number Memory Block Name
7-1 Card Interface Slot Assignment
7-3-01 MIF (LCR) Assignment
7-3-02 MIF (SMDR) Assignment
1-15-00 K-CCIS Main/Remote Office Selection
1-15-02 Common Signal Channel Assignment
1-15-03 Originating Point Code Assignment
1-15-04 Destination Point Code Assignment
1-15-05 Destination Point Code Transfer Assignment
1-15-06 Originating Office Code Number Assignment
1-15-07 K-CCIS Message Response Timeout Assignment
1-15-08 Link Reconnect Allow/Deny Selection
1-15-09 K-CCIS Maximum Call Forwarding Hop Assignment
1-15-11 Centralised Billing Allow/Deny Selection
1 0 : C C H 1 N A M E N O
T I M E D I S P L A Y
Data
No.
Title
Setting
Data
C-Channel
1~4
To Next Page
Loading...
