NEC Xen IPK - Caller Name Indication Selection

386 – Chapter 1 DRAFT 3 Caller Name Indication Selection, 3-53
December 2004 NEC Business Solutions Ltd
Doc. No.: 8194 - Release 2.0 December 2004
3-53
System Mode
3
Submode
—
Data No.
53
PC Programming
+ AI
Caller Name Indication
Selection
General Description
When an Caller ID number is detected, the IPK system can check the speed dialling buffer
for a match. When a name is assigned to a matched number, the name can be displayed,
when allowed by this assignment
.
Display
Settings
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8 The shaded area
indicates the
default setting.
NO
NUM NAM TRK
Programming Procedures
1
Go off-line.
2
Press LK3 + N + EC to access the Memory Block.
3
Press the corresponding CO/PBX line key to change the data option.
Note: Use the following to enter data:
J to move the cursor left
L to move the cursor right
K~I to enter numeric data or CO/PBX No.
– OR –
R to go to the next assigned CO/PBX Line No.
Settings Include:
NO Disables caller name display.
NUM Displays Caller ID presented from the network.
NAMSelected when system speed dial buffers are assigned a name; the name is displayed when it is assigned to a
matched number and Caller ID number matches the speed dial number.
TRK Selected if you want the trunk name or number to display when data is assigned in Memory Block 3-00 (Trunk Name/
Number Assignment).
4
PressNto write the data and display the next Memory Block.
5
Program the next Memory Block or pressPto go back on-line, after all data is written.
Related Programming
M.B. Number Memory Block Name
Refer to individual features in the Xen IPK Features and Specifications manual.
0 1 / 5 3 : I S I N D N U M
T I M E D I S P L A Y
CO/PBX
No.
(01~64)
Data
No.
Title
Setting Data