NEC Xen IPK - First Digit PBR Release Timer Selection

1-3-03, First Digit PBR Release Timer Selection DRAFT 3 Chapter 1 – 155
Xen IPK Programming Manual
Doc. No.: 8194 - Release 2.0 December 2004
1-3-03
System Mode
1
Submode
3
Data No.
03
PC Programming
+ BTI
First Digit PBR Release Timer
Selection
General Description
Use this Memory Block to specify how long a Push Button Receiver (PBR) receiver circuit is
connected when a dual-tone multifrequency (DTMF) Single Line Telephone user goes off-hook.
After the timer expires the PBR is disconnected. If the Single Line Telephone user dials a digit
before the timer expires, a PBR interdigit timer starts.
With IPK R2000 and above, this memory block allows flexible entry and four classes.
For R2000 only.
For R2000 and above.
Display
Settings
LK 1LK 2LK 3LK 4
The shaded area indicates
the default setting.
10 sec. 20 sec. 30 sec. 40 sec.
LK 5 LK 6 LK 7 LK 8
50 sec. 60 sec.
Programming Procedures
1
Go off-line.
2
Press LK1 + LK1 + KC to access the Memory Block.
3
Press the corresponding CO/PBX line key to change data option.
4
PressNto write the data.
5
PressPto go back on-line.
Display
Programming Procedures
1
Go off-line.
2
Press LK1 + LK1 + KC to access the Memory Block.
0 3 : P B R R L S 1 0 s
T I M E D I S P L A Y
Setting
Data
Title
Data
No.
0 3 : P B R R L S 1 0 s
T I M E D I S P L A Y
Setting
Data
Title
Data
No.