NEC Xen IPK - Distinctive Ringing by Telephone or CO Selection

64 – Chapter 1 DRAFT 3 Distinctive Ringing by Telephone or CO Selection, 1-1-28
December 2004 NEC Business Solutions Ltd
Doc. No.: 8194 - Release 2.0 December 2004
1-1-28
System Mode
1
Submode
1
Data No.
28
PC Programming
+ BTS
Distinctive Ringing by
Telephone or CO Selection
General Description
Use this Memory Block to assign distinctive ringing tone for each telephone or each CO/PBX
line.
Display
Settings
LK 1 LK 2 LK 3 LK 4
The shaded area indicates
the default setting.
TEL CO
LK 5 LK 6 LK 7 LK 8
Programming Procedures
1
Go off-line.
2
Press LK1 + LK1 + BH to access the Memory Block.
3
Press the corresponding CO/PBX line key to change the data option.
4
PressNto write the data.
5
PressPto go back on-line.
Related Programming
M.B. Number Memory Block Name
3-07 CO/PBX Ringing Variation Selection
4-01 CO/PBX Ring Assignment (Day Mode)
4-02 CO/PBX Ring Assignment (Night Mode)
4-62 Telephone Ringing Variation Selection
N
1. TEL = Telephone Mode
Ringing tone is specified in Memory Block 4-68 Telephone Ringing Variation Selection.
2. CO = CO/PBX Line Mode
Ringing tone is specified for each CO/PBX line in Memory Block 3-07 CO/PBX Ringing Variation Selection.
2 8 : D S T R I N G T E L
T I M E D I S P L A Y
Data
No. Title
Setting
Data