NEC Xen IPK - CO;PBX Ringing Variation Selection

346 – Chapter 1 DRAFT 3 CO/PBX Ringing Variation Selection, 3-07
December 2004 NEC Business Solutions Ltd
Doc. No.: 8194 - Release 2.0 December 2004
3-07
System Mode
3
Submode
—
Data No.
07
PC Programming
+ BCT
CO/PBX Ringing Variation
Selection
General Description
Use this Memory Block to specify a ringing tone (Low, Medium, or High) for each CO/PBX line.
Display
Settings
LK 1 LK 2 LK 3 LK 4
The shaded area indicates
the default setting.
Medium (M) Low (L) High (H)
LK 5 LK 6 LK 7 LK 8
Programming Procedures
1
Go off-line.
2
Press LK3 + N + KGto access the Memory Block.
3
Press the corresponding CO/PBX line key to change the data option.
Note: Use the following when entering data:
R to go to the next CO/PBX Line No.
4
PressNto write the data.
5
PressPto go back on-line.
Related Programming
M.B. Number Memory Block Name
1-1-28 Distinctive Ringing by Telephone or CO Selection
N
1. This Memory Block is not applicable if Telephone is selected in Memory Block , 1-1-28 , Distinctive Ringing by
Telephone or CO Selection.
2. High, medium, or low ringing tone follows when transferring calls.
0 1 / 0 7 : D S T R I N G = M
T I M E D I S P L A Y
Setting
Data
CO/PBX
No.
(01~64)
Data
No.
Title