NEC Xen IPK - Off-Hook Ringing Selection

4-51, Off-Hook Ringing Selection DRAFT 3 Chapter 1 – 457
Xen IPK Programming Manual
Doc. No.: 8194 - Release 2.0 December 2004
4-51
System Mode
4
Submode
—
Data No.
51
PC Programming
+ BTM
Off-Hook Ringing Selection
General Description
Use this Memory Block to assign Off-Hook Ringing to Multiline Terminals per station.
Display
Settings
LK 1LK 2LK 3LK 4
The shaded area indicates
the default setting.
Ys No
LK 5 LK 6 LK 7 LK 8
Programming Procedures
1
Go off-line.
2
Press LK4 + EA to access the Memory Block.
3
Use the Line Keys to enter the Off-Hook Ringing Selection.
Note: Use the following to enter data:
J to move the cursor left
L to move the cursor right
K~I to enter numeric data
R to select next Tel Port No.
Default Values
All terminals = YS
4
PressNto write the data.
5
PressPto go back on-line.
Related Programming
No related programming is necessary for this Memory Block.
N
Telephone ports A0~C0 are ports 100~120.
0 1 / 5 1 : O F F R I N G Y S
T I M E D I S P L A Y
Data
No.
Tel Port No.
(01~99)
A0~C0
Title
Setting
Data