NEC Xen IPK - Internal Paging Timeout Selection

1-2-00, Internal Paging Timeout Selection DRAFT 3 Chapter 1 – 127
Xen IPK Programming Manual
Doc. No.: 8194 - Release 2.0 December 2004
1-2-00
System Mode
1
Submode
2
Data No.
00
PC Programming
+BP
Internal Paging Timeout
Selection
General Description
Use this Memory Block to program the time allowed for paging.
With IPK R2000 and above, this memory block allows flexible entry and four Classes.
For R2000 only.
For R2000 and above.
Display
Settings
LK 1LK 2LK 3LK 4
The shaded area indicates
the default setting.
90 sec. 120 sec. No Limit
LK 5 LK 6 LK 7 LK 8
Programming Procedures
1
Go off-line.
2
Press LK1 + LK2 + KK to access the Memory Block.
3
Press the corresponding CO/PBX line key to change the data option.
4
PressNto write the data.
5
PressPto go back on-line.
Display
Programming Procedures
1
Go off-line.
2
Press LK1 + LK2 + KK to access the Memory Block.
0 0 : P A G I N G 9 0 s
T I M E D I S P L A Y
Data
No.
Title
Setting
Data
0 0 : P A G I N G X = 0 9 0 s
T I M E D I S P L A Y
Data
No.
Title
Setting
Data
Class