174 – Chapter 1 DRAFT 3 Automated Attendant PBR Timeout Response Selection, 1-4-08
December 2004 NEC Business Solutions Ltd
Doc. No.: 8194 - Release 2.0
December 2004
1-4-08
System Mode
1
Submode
4
Data No.
08
PC Programming
+ AU
Automated Attendant PBR
Timeout Response Selection
General Description
Use this Memory Block to specify how a call answered by the Automated Attendant should be
processed if a dual-tone multifrequency (DTMF) tone is not received.
Display
Settings
LK 1 LK 2 LK 3 LK 4
The shaded area indicates
the default setting.
Normal Call Release
LK 5 LK 6 LK 7 LK 8
Programming Procedures
1
Go off-line.
2
Press LK1 + LK4 + KH to access the Memory Block.
3
Press the corresponding CO/PBX line key to change the data option.
4
PressNto write the data.
5
PressPto go back on-line.
Related Programming
M.B. Number Memory Block Name
Refer to Chapter 2, Guide to Feature Programming.
N
1. When Normal Call is selected, and a DTMF tone is not received during the Automated Attendant message or during
the Automated Attendant Push Button Receiver (PBR) Release Timer time (20-second default), the system rings
selected stations using Memory Block 4-01 [CO/PBX Ring Assignment (Day Mode)] or Memory Block , 4-02 , CO/
PBX Ring Assignment (Night Mode).
2. When Release is selected, and a DTMF tone is not received during the Automated Attendant message or during the
Automated Attendant PBR Release Timer time (20-second default), the system drops the call after 30 seconds
regulated by a fixed timer.
0 8 : A A R E S N O R M A L
T I M E D I S P L A Y
Data
No. Title
Setting
Data
To Next Page
Loading...
