1-4-09, Automated Attendant PBR Start Time Selection DRAFT 3 Chapter 1 – 175
Xen IPK Programming Manual
Doc. No.: 8194 - Release 2.0
December 2004
1-4-09
System Mode
1
Submode
4
Data No.
09
PC Programming
+ AU
Automated Attendant PBR
Start Time Selection
General Description
This Memory Block is used to specify whether the Push Button Receiver (PBR) can receive dual-
tone multi frequency (DTMF) signalling while the Automated Attendant is sending the message
or after the message is complete.
Display
Settings
LK 1LK 2LK 3LK 4
The shaded area indicates
the default setting.
FR AF
LK 5 LK 6 LK 7 LK 8
Programming Procedures
1
Go off-line.
2
Press LK1 + LK4 + KI to access the Memory Block.
3
Press the corresponding CO/PBX line key to change the data option.
Setting Data:
FR: While the Automated Attendant sends the message.
AF: After the Automated Attendant sends the message.
4
PressNto write the data.
5
PressPto go back on-line.
Related Programming
M.B. Number Memory Block Name
Refer to Chapter 2, Guide to Feature Programming.
N
When FR is assigned, the Automated Attendant message send start time and the PBR connected to Automated
Attendant trunk start time are the same.
0 9 : P B R S T R T F R
T I M E D I S P L A Y
Data
No. Title
Setting
Data
To Next Page
Loading...
