NEC Xen IPK - Default Values; SMDR Valid Call Timer Assignment

1-5-25, SMDR Valid Call Timer Assignment DRAFT 3 Chapter 1 – 195
Xen IPK Programming Manual
Doc. No.: 8194 - Release 2.0 December 2004
1-5-25
System Mode
1
Submode
5
Data No.
25
PC Programming
+ AS
SMDR Valid Call Timer
Assignment
General Description
Use this Memory Block to assign the minimum length of a call before the Station Message Detail
Recording (SMDR) outputs a record of the outgoing CO/PBX call.
Display
Programming Procedures
1
Go off-line.
2
Press LK1 + LK5 + BEto access the Memory Block.
3
Use the dial pad to enter data.
 Minimum time assignment is 000 sec.
 Time assignment can be set from 000 sec.~990 sec. in increments of 10 (Setting
Data: 00~99)
Default Values
0 seconds
4
PressNto write the data.
5
PressPto go back on-line.
Related Programming
M.B. Number Memory Block Name
1-1-05 Start Timer Selection
1-5-13 Printer Connected Selection
2 5 : S M D R T I M = 0 0 0 S
T I M E D I S P L A Y
Data
No. Title
Setting
Data