NEC Xen IPK - Route Advance Block Assignment

66 – Chapter 1 DRAFT 3 Route Advance Block Assignment, 1-1-30
December 2004 NEC Business Solutions Ltd
Doc. No.: 8194 - Release 2.0 December 2004
1-1-30
System Mode
1
Submode
1
Data No.
30
PC Programming
+ BCS
Route Advance Block
Assignment
General Description
Use this Memory Block to assign priority levels (1~4) to each Trunk Group assigned in a Route
Advance Block. The system has 32 blocks that can be specified.
Display
Programming Procedures
1
Go off-line.
2
Press LK1 + LK1 + CK to access the Memory Block.
3
Enter the data using the dial pad.
Note: Use the following to enter data:
J to move the cursor left
L to move the cursor right
K~I to enter numeric data
Default Values
All Blocks (00)
4
PressNto write the data. Data for the Priority Nos. 2~4 are displayed in succession.
5
After entering the data for Priority No. 4, pressNto write the data. Data for Priority 1 for the next Block No. is displayed.
6
After entering data for Block No. 32, pressNto write the data. The next Memory Block is displayed.
7
PressPto go back on-line.
Related Programming
M.B. Number Memory Block Name
3-03 Trunk-to-Trunk Group Assignment
3 0 : R T A D V 0 1 - 1 = 0 0
T I M E D I S P L A Y
Data
No.
Block
No.
(1~16)
Title
Setting
Data
Priority
No.
(1~4)
Block No. Priority No. Setting Data
1
1 Trunk Groups 01~32
2 Trunk Groups 01~32
3 Trunk Groups 01~32
4 Trunk Groups 01~32
32
1 Trunk Groups 01~32
2 Trunk Groups 01~32
3 Trunk Groups 01~32
4 Trunk Groups 01~32
∼ ∼ ∼