312 – Chapter 1 DRAFT 3 Centralised Billing Allow/Deny Selection, 1-15-11
December 2004 NEC Business Solutions Ltd
Doc. No.: 8194 - Release 2.0
December 2004
1-15-11
System Mode
1
Submode
15
Data No.
11
PC Programming
+ AW
Centralised Billing Allow/
Deny Selection
General Description
Use this Memory Block to assign the Electra Elite IPK to send billing to the Billing Center
Office (NEAX2000/2400) across the K-CCIS network. Xen IPK does not support receiving
and managing billing information
.
Applicable for IPK R2000 and above.
Display
Settings
LK1 LK2 LK3 LK4 LK5 LK6 LK7 LK8
The shaded area indicates
the default setting.
NO
(Deny)
YS
(Allow)
Programming Procedures
1
Go off-line.
2
Press LK1 + LK15 + AA to access the Memory Block.
3
Press the corresponding CO/PBX line key to change the option.
4
PressNto write the data.
5
PressPto go back on-line.
Related Programming
M.B. Number Memory Block Name
7-1 Card Interface Slot Assignment
7-3-01 MIF (LCR) Assignment
7-3-02 MIF (SMDR) Assignment
1-15-00 K-CCIS Main/Remote Office Selection
1-15-02 Common Signal Channel Assignment
1-15-03 Originating Point Code Assignment
1-15-04 Destination Point Code Assignment
1-15-05 Destination Point Code Transfer Assignment
1-15-06 Originating Office Code Number Assignment
1-15-07 K-CCIS Message Response Timeout Assignment
1-15-08 Link Reconnect Allow/Deny Selection
1-15-09 K-CCIS Maximum Call Forwarding Hop Assignment
1 1 : B I L L I N G N O
T I M E D I S P L A Y
Data
No.
Title
Setting
Data
To Next Page
Loading...
