NEC Xen IPK - DID Line Ringing Pattern Selection

1-1-55, DID Line Ringing Pattern Selection DRAFT 3 Chapter 1 – 95
Xen IPK Programming Manual
Doc. No.: 8194 - Release 2.0 December 2004
1-1-55
System Mode
1
Submode
1
Data No.
55
PC Programming
+ ALN
DID Line Ringing Pattern
Selection
General Description
This Memory Block assigns the ringing pattern to be used for DID calls.
Display
Settings
LK 1 LK 2 LK 3 LK 4
Ring Pattern A Ring Pattern B
Ring Pattern C Ring Pattern D
LK 5 LK 6 LK 7 LK 8
Ring Pattern E Ring Pattern F Ring Pattern G Ring Pattern H
The shaded area indicates
the default setting.
LK 9 LK 10 LK 11 LK 12
No ring
LK 13 LK 14 LK 15 LK 16
Programming Procedures
1
Go off-line.
2
Press LK1 + LK1 + EE to access the Memory Block.
3
Press the corresponding CO/PBX line key to change the data option.
Note: Use the following to change page:
S to move to next page
T to move to previous page
4
PressNto write the data.
5
PressPto go back on-line.
Related Programming
M.B. Number Memory Block Name
1-1-20 DID Digit Length Selection
1-1-21 DID Digit Conversion Assignment
1-1-22 DID Digit Conversion Table & DNIS Assignment
5 5 : D I D P T N C | 1
T I M E D I S P L A Y
Data
No.
Title
Setting
Data
Page
No.