NEC Xen IPK - Press the Corresponding CO;PBX Line Key to Change the Data Option; SMDR Print Format

1-5-02, SMDR Print Format DRAFT 3 Chapter 1 – 191
Xen IPK Programming Manual
Doc. No.: 8194 - Release 2.0 December 2004
1-5-02
System Mode
1
Submode
5
Data No.
02
PC Programming
+ AS
SMDR Print Format
General Description
Use this Memory Block to specify whether or not ALL digits are to be printed. If All is specified, all
digits are printed. If MASK is specified, the last four digits are masked and XXXX is printed.
Display
Settings
LK 1LK 2LK 3LK 4
The shaded area indicates
the default setting.
All Mask
LK 5 LK 6 LK 7 LK 8
Programming Procedures
1
Go off-line.
2
Press LK1 + LK5 + KB to access the Memory Block.
3
Press the corresponding CO/PBX line key to change the data option.
4
PressNto write the data.
5
PressPto go back on-line.
Related Programming
M.B. Number Memory Block Name
1-5-13 Printer Connected Selection
0 2 : F O R M A T A L L
T I M E D I S P L A Y
Data
No. Title
Setting
Data