NEC Xen IPK - Automated Attendant Delay Announcement Disconnect Time Selection

1-4-20, Automated Attendant Delay Announcement Disconnect Time Selection DRAFT 3 Chapter 1 – 187
Xen IPK Programming Manual
Doc. No.: 8194 - Release 2.0 December 2004
1-4-20
System Mode
1
Submode
4
Data No.
20
PC Programming
+ AU
Automated Attendant Delay
Announcement Disconnect
Time Selection
General Description
Use this Memory Block to establish how long the Automated Attendant rings the stations before
disconnecting the caller. This Memory Block only applies when the Automated Attendant is set to
the Delay Announcement Mode.
Display
Settings
LK 1 LK 2 LK 3 LK 4
The shaded area indicates
the default setting.
Immediate
(0s)
10 sec.
(10s)
20 sec.
(20s)
30 sec.
(30s)
LK 5 LK 6 LK 7 LK 8
1 min.
(1m)
2 min.
(2m)
3 min.
(3m)
4 min.
(4m)
LK9 LK10 LK11 LK12
5 min.
(5m)
10 min.
(10m)
20 min.
(20m)
Programming Procedures
1
Go off-line.
2
Press LK1 + LK4 + BKto access the Memory Block.
3
Press the corresponding CO/PBX line key to change the data option.
Example: To change 30 seconds to 10 seconds, press CO/PBX line key 2.
Default Values
Specified in the shaded area.
4
Press N to write the selected data and advance to Memory Block , 1-5-02 , SMDR Print Format.
5
PressP to go back on-line.
Related Programming
M.B. Number Memory Block Name
1-4-18 Automated Attendant Delay Announcement Assignment
1-4-19 Automated Attendant 1
st
to 2
nd
Delay Announcement Interval Time Selection
2 0 : 2 n d I N T R V L 3 0 s
T I M E D I S P L A Y
Data
No.
Title
Setting
Data