3-24, Tie Line Incoming Interdigit Timeout Selection DRAFT 3 Chapter 1 – 363
Xen IPK Programming Manual
Doc. No.: 8194 - Release 2.0
December 2004
3-24
System Mode
3
Submode
—
Data No.
24
PC Programming
+ ALM
Tie Line Incoming Interdigit
Timeout Selection
General Description
Use this Memory Block to specify a time interval during the incoming call detection process so
that if an address signal is not received within a specified time, an error tone is returned to the
other system.
Display
(Page 1)
LK 1LK 2LK 3LK 4
The shaded area indicates
the default setting.
No Limit 1 sec. 2 sec. 3 sec.
LK 5 LK 6
LK 7 LK 8
4 sec. 5 sec.
6 sec. 7 sec.
(Page 2)
LK 1LK 2LK 3LK 4
8 sec. 9 sec. 10 sec. 11 sec.
LK 5 LK 6 LK 7 LK 8
12 sec. 13 sec. 14 sec. 15 sec.
Programming Procedures
1
Go off-line.
2
Press LK3 + N + BD to access the Memory Block.
3
Press the corresponding CO/PBX line key to change the data option.
Note: Use the following enter data:
S to go to the next page
T to go to the previous page
R to go to the next CO/PBX Line No.
4
PressNto write the data.
5
PressPto go back on-line.
Related Programming
No related programming is necessary for this Memory Block.
0 1 / 2 4 : I N C O M 6 s | 1
T I M E D I S P L A Y
CO/PBX
No.
(01~64)
Data
No.
Title
Page
No.
Setting
Data
To Next Page
Loading...
