NEC Xen IPK - Hold;Transfer Recall Display Selection

436 – Chapter 1 DRAFT 3 Hold/Transfer Recall Display Selection, 4-30
December 2004 NEC Business Solutions Ltd
Doc. No.: 8194 - Release 2.0 December 2004
4-30
System Mode
4
Submode
—
Data No.
30
PC Programming
+ BTM
Hold/Transfer Recall Display
Selection
General Description
Use this memory block to enable/disable the Hold Recall indication on the LCD.
Display
Settings
LK 1 LK 2 LK 3 LK 4
The shaded area indicates
the default setting.
Ys No
LK 5 LK 6 LK 7 LK 8
Programming Procedures
1
Go off-line.
2
Press LK4 +CK to access the Memory Block.
3
Press the corresponding CO/PBX line key to change data option.
4
PressNto write the data.
5
PressPto go back on-line.
Related Programming
No related programming is necessary for this Memory Block.
N
1. If this Memory Block is assigned Yes, the Hold Recall is displayed in place of the Time Display.
2. LCD indication of the CO line number is displayed on the upper line of the display when a recall occurs, regardless of
the assignment for this Memory Block.
3. Telephone ports A0~C0 are ports 100~120.
0 1 / 3 0 : H L D D S P Y S
T I M E D I S P L A Y
Data
No.
Tel Port No.
(01~99)
A0~C0
Setting
Data
Title