1-11-00, T1 Signal Format Selection DRAFT 3 Chapter 1 – 261
Xen IPK Programming Manual
Doc. No.: 8194 - Release 2.0
December 2004
1-11-00
System Mode
1
Submode
11
Data No.
00
PC Programming
+ AD
T1 Signal Format Selection
General Description
Use this Memory Block to specify the signal format of the T1 trunk connected to the
system. The signal format used (12- or 24-Multiframe) depends on the channel service unit/
demarcation (CSU/D mark) equipment being used.
System Software R2000 or higher is required.
Display
Settings
LK1 LK2 LK3 LK4 LK5 LK6 LK7 LK8
The shaded area indicates
the default setting.
12
(SF)
24
(ESF)
Programming Procedures
1
Go off-line.
2
Press LK1 + LK11 to access the Memory Block.
3
Press the corresponding CO/PBX line key to change the data option.
Note: Setting Data:
SF = Superframe Format (12-Multiframe)
ESF = Extended Superframe Format (24-Multiframe)
4
PressNto write the data. The next Memory Block is displayed.
5
Program the next Memory Block or pressPto go back on-line.
Related Programming
M.B. Number Memory Block Name
7-1 Card Interface Slot Assignment
Related Programming
No related programming is necessary for this Memory Block.
N
The DTI-U( ) ETU must be assigned in the system to set this Memory Block.
0 1 / 0 0 : F R A M E = 2 4
T I M E D I S P L A Y
Data
No.
Title
Setting
Data
DTI No.
(01~03)
To Next Page
Loading...
