NEC Xen IPK - DIT Tenant Assignment

392 – Chapter 1 DRAFT 3 DIT Tenant Assignment, 3-62
December 2004 NEC Business Solutions Ltd
Doc. No.: 8194 - Release 2.0 December 2004
3-62
System Mode
3
Submode
—
Data No.
62
PC Programming
+ BCT
DIT Tenant Assignment
General Description
This Memory Block is used to assign a CO/PBX Line to each tenant for incoming DIT calls.
1-Line Number to be Displayed (3-53 = Number)
Display
Programming Procedures
1
Go off-line.
2
Press LK3 + N + DDto access the Memory Block.
3
Press the corresponding CO/PBX line key to change the data option.
Note: Use the following to enter data:
J to move the cursor left
L to move the cursor right
K~I to enter numeric data
Default Values
All CO/PBX Lines are set to tenant 00.
4
PressNto write the data.
5
PressPto go back on-line.
Related Programming
M.B. Number Memory Block Name
4-09 Telephone to Tenant Assignment
MB , 3-70 = CO MB , 3-70 = SPD
Name Supplied – SPD Match
CO Number CO Number
Clock Clock
Name Supplied – No SPD Match
CO Number CO Number
Clock Clock
No Name Supplied – SPD Match
CO Number CO Number
Clock Clock
No Name Supplied – No SPD Match
CO Number CO Number
Clock Clock
0 1 / 6 2 : D I T = T N T 0 0
T I M E D I S P L A Y
CO/PBX
No.
(01~64)
Data
No.
Title
Tenant No.
(00~47)