NEC Xen IPK - Direct Inward Termination; Direct Paging Access; Direct Station Selection; Distinctive Ringing

Xen IPK Programming Manual
Section 2, Programming Guide Tables DRAFT 3 Chapter 2 – 571
Doc. No.: 8194 - Release 2.0 December 2004
Direct Inward Termination
Menu Access
Keyboard Shortcut
System Data Name Memory Block
z
+BT
Call Forward No Answer Timer Selection 1-2-22
z
+BCT  DIT Assignment
3-42
z
+BCT
 ANA Assignment
3-43
z
+BTT
Call Forward – Busy Immediately/Delay Selection 4-42
Direct Paging Access
Menu Access
Keyboard Shortcut
System Data Name Memory Block
z
+BA
Access code (1-, 2- or 3-Digit) Assignment 1-1-46/47/48
z
+BTD
Attendant Add-On Console Key Assignment 1-6-05
z
+BTM
Line Key Selection Telephone Mode 4-12
Direct Station Selection
Menu Access
Keyboard Shortcut
System Data Name Memory Block
z
+BTD
Attendant Add-On Console to Telephone Port Assignment 1-6-01
z
+BTD
DSS Call Voice/Tone Selection 1-6-03
z
+BTD
Attendant Add-On Console Key Selection 1-6-05
z
+BN
Line Key Selection 2-05
z
+BN
Line Key Selection for Tenant Mode 2-06
z
+BTM
Line Key Selection for Telephone Mode 4-12
z
+BS
Card Interface Slot Assignment 7-2
Distinctive Ringing
Menu Access
Keyboard Shortcut
System Data Name Memory Block
z
+BT
CO/PBX Incoming Ringing alarm Time Selection 1-1-06
z
+BTS
Distinctive Ringing by Telephone or CO Selection 1-1-28
z
+BCS
CO Line Ringing Pattern Selection 1-1-51
z
+BCS
PBX Line Ringing Pattern Selection 1-1-52