1-1-74, Second Delay Announcement Repeat Selection DRAFT 3 Chapter 1 – 115
Xen IPK Programming Manual
Doc. No.: 8194 - Release 2.0
December 2004
1-1-74
System Mode
1
Submode
1
Data No.
74
PC Programming
+ AR
Second Delay Announcement
Repeat Selection
General Description
Use this Memory Block to specify the number of times a Second Delay Announcement is
repeated.
Display
Settings
LK 1LK 2LK 3LK 4
The shaded area indicates
the default setting.
1 Time 2 Times 3 Times 4 Times
LK 5LK 6LK 7LK 8
5 Times 6 Times 7 Times 8 Times
Programming Procedures
1
Go off-line.
2
Press LK1 + LK1 + GD to access the Memory Block.
3
Press the corresponding CO/PBX line key to change the data option.
4
PressNto write the data.
5
PressPto go back on-line.
Related Programming
M.B. Number Memory Block Name
1-1-73 First to Second Delay Announcement Interval Time Selection
1-1-75 Second Delay Announcement Repeat Interval Time Selection
1-8-12 VRS Message Recording Time Selection
1-8-13 VRS Message Function Assignment
3-43 ACD/UCD Delay Announcement Assignment
N
1. This Memory Block does not display unless the MIFA-U( ) ETU is installed.
2. This Memory Block does not display unless the MIFA-U( ) ETU is installed.
3. When Memory Block 2-08 is used, this is the number of times the message is played back-to-back. After this is done,
the system looks at 1-1-75 to repeat the procedure.
7 4 : M S G 2 S E N D = 1
T I M E D I S P L A Y
Data
No.
Setting
Data
Title
To Next Page
Loading...
