NEC Xen IPK - ISDN Extension-Based Caller ID Assignment

4-62, ISDN Extension-based Caller ID Assignment DRAFT 3 Chapter 1 – 467
Xen IPK Programming Manual
Doc. No.: 8194 - Release 2.0 December 2004
4-62
System Mode
4
Submode
—
Data No.
62
PC Programming
+ BTT
ISDN Extension-based Caller
ID Assignment
General Description
This Memory Block provides the station DID Number (CPN, Calling Party Number) to the
Network when placing outgoing calls.
Display
Programming Procedures
1
Go off-line.
2
Press LK4 +FB to access the Memory Block.
3 Use the following to enter data:
Jto move the cursor left.
Lto move the cursor right.
K~Ito enter numeric data.
– OR –
Press
Rto go to the next TEL port number.
Press
Uto clear data.
Setting Data:
Telephone number to be programmed must
include area code, minus leading 0.
e.g.: 3 X X X X – X X X X
4
PressNto write the data and display Memory Block , 4-01.
5
Program Memory Block , 4-01 or pressP to go back on-line.
Related Programming
M.B. Number Memory Block Name
3-53 ISDN Trunk Directory Number Assignment
3-91 Trunk Type Selection
4-47 ISDN Directory Number Selection
N
1. A maximum of 13 digits is allowed.
2. Hyphens/dashes are not allowed when entering the directory number.
3. This Memory Block supports only trunks assigned as DID in Memory Block , 3-91.
4. When using CO Line Mode, Memory Block , 3-53 is used to assign the directory number of ISDN.
5. Only numbers within the indial range are valid.
0 1 / 6 2 :
T I M E D I S P L A Y
Data
No.
Tel Port No.
(01~CO)
Setting
Data