NEC Xen IPK - Automated Attendant Transfer Ring Pattern

1-1-54, Automated Attendant Transfer Ring Pattern DRAFT 3 Chapter 1 – 93
Xen IPK Programming Manual
Doc. No.: 8194 - Release 2.0 December 2004
1-1-54
System Mode
1
Submode
1
Data No.
54
PC Programming
+ AU
Automated Attendant Transfer
Ring Pattern
General Description
Use this Memory Block to specify the ringing pattern sent to the Multiline Terminal when an
incoming call is received at the Automated Attendant and transferred.
Display
Settings
(Page 1)
LK 1 LK 2 LK 3 LK 4
Ring Pattern A Ring Pattern B
Ring Pattern C Ring Pattern D
LK 5 LK 6 LK 7 LK 8
Ring Pattern E Ring Pattern F Ring Pattern G Ring Pattern H
(Page 2)
The shaded area indicates
the default setting.
LK 9 LK 10 LK 11 LK 12
No Ring
LK 13 LK 14 LK 15 LK 16
Programming Procedures
1
Go off-line.
2
Press LK1 + LK1 + ED to access the Memory Block.
3
Press the corresponding CO/PBX line key to change the data option.
Note: Use the following to enter data:
Sto access the next page
Tto access the previous page
4
PressNto write the data.
5
PressPto go back on-line.
Related Programming
M.B. Number Memory Block Name
Refer to Chapter 2 Guide to Feature Programming.
5 4 : A A P T N C | 1
T I M E D I S P L A Y
Data
No.
Title
Setting
Data
Page
No.