NEC Xen IPK - APR Ring Mode Assignment

4-39, APR Ring Mode Assignment DRAFT 3 Chapter 1 – 445
Xen IPK Programming Manual
Doc. No.: 8194 - Release 2.0 December 2004
4-39
System Mode
4
Submode
—
Data No.
39
PC Programming
+ BTM
APR Ring Mode Assignment
General Description
Use this Memory Block to specify the ringing mode for an Single Line Telephone connected to
the APR-U.
Display
Settings
LK 1 LK 2 LK 3 LK 4
The shaded area indicates
the default setting.
No Ring
Station
Number
only
All Ring
LK 5 LK 6 LK 7 LK 8
Programming Procedures
1
Go off-line.
2
Press LK4 +CI to access the Memory Block.
3
Press the corresponding CO/PBX line key to change data option.
Note: Use the following to enter data:
R select next Tel Port No.
4
PressNto write the data.
5
PressPto go back on-line.
Related Programming
No related programming is necessary for this Memory Block.
N
1. No Ring means that no calls ring at the Single Line Telephone.
2. Station Number ring means that only calls directed to the Multiline Terminal Station Number, ring at the Single
Line Telephone.
3. All Ring means that all calls that ring at the Multiline Terminal also ring at the Single Line Telephone.
4. Telephone ports A0~C0 are ports 100~120.
0 1 / 3 9 : A D A 2 = S T A
T I M E D I S P L A Y
Data
No.
Tel Port No.
(01~99)
A0~C0
Title
Setting
Data