1-11-07, DTI Trunk Type Assignment DRAFT 3 Chapter 1 – 267
Xen IPK Programming Manual
Doc. No.: 8194 - Release 2.0
December 2004
1-11-07
System Mode
1
Submode
11
Data No.
07
PC Programming
+ AD
DTI Trunk Type Assignment
General Description
Use this Memory Block to assign the trunk type (CO/E&M Tie line/DID/ANI) four channels at
a time. Assignment to an individual channel is impossible
.
Applicable for R2000 and above.
Display
Settings
LK1 LK2 LK3 LK4 LK5 LK6 LK7 LK8
The shaded area indicates
the default setting.
CO E&M DID ANI
Programming Procedures
1
Go off-line.
2
Press LK1 + LK11 + KG to access the Memory Block.
3
Press the corresponding CO/PBX line key to change the data option.
4
PressNto write the data. The next Memory Block is displayed.
5
Program the next Memory Block or pressPto go back on-line.
Related Programming
M.B. Number Memory Block Name
1-11-06 Signalling Selection
7-1 Card Interface Slot Assignment
N
1. A DTI-U( ) ETU must be assigned in the system to set this Memory Block.
2. When the default setting is changed to E&M or DID, the affected trunks are automatically reassigned to Trunk Group
00. When trunks 01 ~ 08 are affected, default line key assignment for all Multiline Terminals changes to Not Used and
must also be reassigned. Memory Block 3-14 resets to second dial.
0 1 / 0 7 T R K ( 1 ) C O
T I M E D I S P L A Y
Data
No.
Title
Setting
Data
DTI No.
(01~08)
Block
No.
4-Channel Unit
DTI
No. 1
DTI
No. 2
DTI
No. 3~8
1 01~04 01~04 01~04
2 05~08 05~08 05~08
3 09~12 09~12 09~12
4 13~16 13~16 13~16
5 17~20 17~20 17~20
6 21~24 21~24 21~24
To Next Page
Loading...
