NEC Xen IPK - Private Line Assignment

1-1-29, Private Line Assignment DRAFT 3 Chapter 1 – 65
Xen IPK Programming Manual
Doc. No.: 8194 - Release 2.0 December 2004
1-1-29
System Mode
1
Submode
1
Data No.
29
PC Programming
+ BCS
Private Line Assignment
General Description
Use this Memory Block to assign an outside line for use as a private line. The private line cannot
be seized by any other telephone, and no LED indication is provided to other terminals.
Display
Programming Procedures
1
Go off-line.
2
Press LK1 + LK1 + BI to access the Memory Block.
3
Enter the data using the dial pad.
Note: Use the following to enter data:
J to move the cursor left
L to move the cursor right
K~I to enter numeric data
U to clear all data when cursor is at CO No. or Tel. Port No.
Default Values
Not Specified
4
PressNto write the data. Data for the second line is displayed. Move the cursor to change the data.
5
PressNto write the data.
6
PressPto go back on-line.
Related Programming
M.B. Number Memory Block Name
2-06 Line Key Selection for Tenant Mode
4-12 Line Key Selection for Telephone Mode
N
1. Two private lines can be assigned to one station or one private line can be assigned to two stations.
2. A Single Line Telephone (SLT) user cannot dial the Trunk Group Access Code to access a private line. The Single
Line Telephone user can access the line by dialling the specified Line Seizure Access Code assigned in Memory
Blocks 1-1-46/ 1-1-47 Access Code (1-digit/2 -digit) Assignment (Function 063 or 064).
3. If a station is allowed Barge-In originate, and a second station is allowed Barge-In receive, Barge-In is not allowed on
a private line unless both stations share the private line.
2 9 : P 1 C = T =
T I M E D I S P L A Y
Data
No.
Combination
No.
(1/2)
Title
CO No.
(01~64)
Tel. Port No.
(01~CO)