5-04, LCR Class to Trunk Group Selection DRAFT 3 Chapter 1 – 487
Xen IPK Programming Manual
Doc. No.: 8194 - Release 2.0
December 2004
5-04
System Mode
5
Submode
—
Data No.
04
PC Programming
+ AW
LCR Class to Trunk Group
Selection
General Description
Use this Memory Block per trunk group to specify the Least Cost Routing (LCR)/Automatic
Carrier Routing (ACR) Class. For systems connected using K-CCIS, the Electra Elite can
analyze incoming telephone numbers received from a distant system and use the LCR/ARS
assignments to route the call to its desired destination
.
Applicable for IPK R2000 and above.
Display
Settings
LK1 LK2 LK3 LK4 LK5 LK6 LK7 LK8
The shaded area indicates
the default setting.
01234
Programming Procedures
1
Go off-line.
2 Press LK5 +N+KDto access the Memory Block.
3 Press the corresponding CO/PBX line key to change the Setting Data option.
4 Press
Nto write the data. The next Memory Block is displayed.
5 Program the next Memory Block or press
Pto go back on-line.
Related Programming
M.B. Number Memory Block Name
3-70 CIC Number Assignment
1-1-05 Start Time Selection
1-1-46~48 Access Code (1-, 2- or 3-Digit) Assignment
1-15-00 K-CCIS Main/Remote Office Selection
1-15-02 Common Signal Channel Assignment
1-15-03 Originating Point Code Assignment
1-15-04 Destination Point Code Assignment
1-15-05 Destination Point Code Transfer Assignment
1-15-06 Originating Office Code Number Assignment
1-15-07 K-CCIS Message Response Timeout Assignment
1-15-08 Link Reconnect Allow/Deny Selection
0 1 / 0 4 : C L A S S 0
T I M E D I S P L A Y
Trunk Group No.
(01~32)
Data
No.
Title
Setting
Data
To Next Page
Loading...
